7
Operate the device only after having familiarized with its functions. Do not allow an
operation by persons who do not know the device well enough. Most damages are the
result of unprofessional operation!
Please consider that unauthorized modifications to the device are forbidden due to safety
regulations!
INTRODUCTION
Thank you for having chosen a FOAM 1500. You have acquired a rugged, reliable and
powerful device. If you follow the instructions given in this manual, we can assure you that
you will enjoy this device for many years.
Unpack your FOAM 1500.
Please make sure that there are no obvious transport damages. Should you notice any
damages at the A/C connection cable or at the casing, immediately consult your local
dealer and do not take the device into operation.
CONNECTING TO MAINS
Caution! Only qualified staff is allowed to carry out the connection.
The A/C connection cable's green/yellow wire is the earthing conductor. The blue and the
green wire carry the voltage.
INSTALLATION
When installing the device, make sure that the venting slots are not covered by decoration
material. In order to safeguard sufficient ventilation, leave 10 cm of free space around the
device.
The best effects can be obtained if you install the machine independantly, e.g. on a small
table.
Caution! Ensure a minimum distance between foam machine and audience of min. 2m.
Never direct the foam output nozzle to the face or the eyes of people.
Due to its construction, the nozzle may produce liquid droplets. Consider the dropping of
this liquid when chosing the location for installing the device.
In general, the foam dissolves without leaving any residues. Once in a while, the fluid may
leave residues on the floor or the clothing; these can easily be removed.
Caution! This foam machine is not splash-proofed. Only for inside usage.
If liquids happen to enter the device, immediately disconnect from mains and consult a
specialist.
Caution! Never run the device with empty tank. Disconnect from mains before re-fill. Only
use fluid recommended by the manufacturer.
Before you initial start-up, fill the foamfluid tank. Only use high-quality fluids like
EUROLITE fluid, because the pump could be clogged otherwise. Always make sure that
the tank is filled sufficiently. Damages caused by the non-observence of these
instructions are not subject to warranty!
OPERATION
Plug the device in and switch the power switch on the rear panel. The device starts
running.
Caution! Only adults are allowed to operate this device. Always disconnect from mains or
switch off power switch when not using the device.
Never leave the foam machine without observation.