00103656, Version 1.0
27/36
OPERATION
After you connected the effect to the mains, the EUROLITE LED MSB-8i starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
Stand-alone operation
In the Stand-alone mode, the LED MSB-8i can be used without controller.
Disconnect the LED MSB-8i from the controller and call the internal program. Please refer to the instructions
under Control Board.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the back panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired internal program or the test function - for the master device, as described in chapter Control
Board. Set the DMX address 001 for all slave-devices.
