00074359, Version 1.0
21/23
STAND-ALONE MODE
In Stand-Alone Mode, the LED ML-30 UV 7x1W spot can be used without a controller. Disconnect the device
from the controller.
Dimming
Press the MODE button until the LED display shows a
C
.
You can select the desired brightness level via the UP or DOWN buttons (from C-0 to C-9, increasing
brightness / default setting C-9).
Sound control / Sensitivity
Press the MODE button until the LED display shows an
S
.
You can select the desired sensitivity level via the UP or DOWN buttons (from S-0 to S-9, increasing
sensitivity / default setting S-5).
Master / Slave
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED ML-30 UV 7x1W spot you can find an XLR-jack and an XLR-plug, which can be
used for connecting several devices.
This device then works as master-device and controls the slave-devices, which are to be connected to the
master-device via a stereo shielded cable.
Connect the DMX OUT jack with the DMX IN plug of the next device.
Press the MODE button until the LED display shows
SLA
. The devices set in this manner can now be
controlled by the master unit.
Flash
Press the MODE button until the LED display shows an
F
.
You can select the desired flash speed via the UP or DOWN buttons (from F-0 to F-9, increasing speed /
default setting F-5).
DMX MODE
The LED screen allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED UV Bars will respond to the controller.
Addressing
Press the MODE button until the LED screen shows
Add
. You can now set the desired address via the UP
or DOWN buttons.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
DMX-controlled operation
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The individual DMX channels and their charateristics are listed under
DMX-protocol
.
