00074359, Version 1.0
20/23
FUNCTION
BUTTON
MODE
DMX
ST
AND-ALONE
DIMMING: 20%, 50%, 100%
: via +/- to set brightness
corresponding to manual C-0 to C-9.
Brightness setting
OFF
Blackout
STROBE: 20%, 50%, 100%
Flash setting: via +/- to set speed
corresponding to manual F-0 to F-9.
OFF
Flash off
SL
SA
D
S
Slave mode
Sound active mode
DMX mode: via +/- to set DMX address
from 001 to 512
Fast address setting
For example: to set address 256, please press
the
button, then press buttons 2, 5, 6.
S
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the device to the mains, the EUROLITE LED ML-30 UV 7x1W spot starts running.
The LED screen lights up and you can choose the desired settings.
The device has two operating modes. It can be operated in Stand-Alone mode via IR remote control, via LED
screen with operating buttons or in DMX mode via a DMX controller.
Operation via remote control
Direct the remote control towards the IR sensor on the device front. The maxium operating range is 10
meters.
Operation via LED screen
The LED screen offers several features: you can program the desired operating mode or set the starting
address.
Browse through the main menu by pressing the MODE button.
You can change the selection by pressing the UP / DOWN buttons.
The functions provided are described in the following sections.
The display shuts off after 30 seconds of inactivity. With the touch of a button it lights up again.
STAND-ALONE-MODE
Dimming
Sound control / Sensitivity
Master / Slave
Flash
DMX MODE
