EuroLite LED TMH-S200, Руководство пользователя

Страница: 28 / 36

00128934, Version 1.0 28/36
Connection to the mains
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the enclosed mains cable to a grounded mains socket.
2 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
OPERATION
With the power switch, you can switch the device on and off. After you connected the effect to the mains, the
device starts running. During the Reset, the motors are trimmed and the device is ready for use afterwards.
The operating modes can be selected by means of the display and the control buttons. All settings remain
stored even if the device is disconnected from the mains.
The device has two operating modes. It can be operated in stand-alone mode via the control board or in
DMX-controlled mode via any commercial DMX controller and wireless via QuickDMX with the optional
available EUROLITE QuickDMX USB Wireless Transmitter/Receiver.
Stand-alone operation
In stand-alone mode, the LED TMH-S200 can be used without controller. Disconnect the LED TMH-S200
from the controller and call up the internal program. Please refer to the instructions under
Control Board .
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the master device to the desired master mode “Auto1”, “Auto2”, “Random” or “Sound”. Set all slave
devices to the mode “DMX”. Please refer to the instructions under
Control Board .