EuroLite LED TMH-16, Руководство пользователя

Страница: 28 / 32

00101665, Version 1.0 28/32
Select temperature designation
With this function you can select the temperature designation.
• Select
“Temp C/F” by pressing Up or Down.
• Press Up or Down to select the desired degree between “Celsius” and “Fahrenheit”.
• Press the Enter-button to confirm.
Reload Default
With this function you can restore the factory settings of the device. The different settings (marked in the
table) will be set back to the default values (shaded).
Reset
With this function you can reset the device via the Control Board.
Adjust
Calibration (Calit CH)
With this function, you can calibrate PAN and TILT to their correct starting positions. The password for this
function is
„050“.
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-16 will respond to the controller.
If you set, for example, the address to channel 16, the device will use the channel 16 to 30 for control.
Please, be sure that you don’t have any overlapping channels in order to control each LED TMH-16 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-16 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-16 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.