EuroLite LED THA-100F MK3, Руководство пользователя, Страница: 27 / 32

00133815, Version 1.0 27/32
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear of the device you can find XLR-jacks (DMX Out) and XLR-plugs (DMX In), which can be used for
connecting several devices.
Choose the device which is to control the effects. Set the desired Master-mode on the master-device. This
device then works as master-device and controls all other slave-devices, which are to be connected to the
master-device via a DMX-cable. Connect the DMX out connectors with the DMX input plug of the next
device.
Set the Slave-mode on every slave-device.
Dimming:
Press the MODE button until the display shows DIMMER.
Press the ENTER button to select brightness and flash
settings, respectively. You can select the desired brightness
(C00-99) or Flash speed (F00-99) via the UP or DOWN
buttons. Confirm your choice by pressing ENTER.
DMX-controlled operation
The device has 2 DMX channel modes. The Control Board allows you, as described above, to assign the
DMX-Mode.
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
If you set, for example, the address to channel 4, the device will use the channel 4 to 6 for control.
DMX mode:
Press the MODE button until the display shows DMX MODE.
Press the ENTER button. You can select the desired DMX
address via the UP or DOWN buttons. Confirm your choice by
pressing ENTER.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.