EuroLite LED Super Strobe ABL, Руководство пользователя

Страница: 21 / 28

00119586, Version 1.1 21/28
Power supply of further devices
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect
the jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power
cables with IEC plugs are available as accessories. In this manner, up to 8 devices can be linked at 230/240
input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.
Menüstruktur
Modus
Anzeige
Funktion
DMX start address Addr
A001 – A512
DMX start address
DMX channel mode **CH
148CH
148-channel mode
22CH
22-channel mode
13CH
13-channel mode
7 CH
7-channel mode
Master/Slave mode SLNA SLNA Master/Slave mode
Sound control
SoUn So – 0-16 Program 0-16
SE 00-99
Microphone sensitivity
low > high
Automatic mode
Auto Au – 0-16 Program 0-16
SP 00-99
Program running speed
slow > fast
LED LED ON/OFF
Display shutoff
Shuts off the display after about 30
seconds
Display DISP
Display setting
With this function you can to turn
the display at 180° upside down
Version
Ver V11 Software Version
Stand-alone mode
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLNA is indicated in the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Do not connect a DMX controller to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in
synchronously.