00085624, Version 1.1
11/12
ATTACHMENT
Attention: Permanent installation is recommended!
Before attaching the product, make sure that the installation area can hold a minimum point load of 10 times
the product's weight.
The product must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the product is installed absolutely planar by using a water-level.
The product must be installed out of the reach of people.
The product must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
The hole for the installation is on the mounting bracket.
Step 2:
Hold the mounting bracket onto the location where the product is to be installed.
Step 3:
Mark the borehole with a pen or a suitable tool.
Step 4:
Drill the hole.
Step 5:
Hold the product in the desired position and tighten it.
OPERATION
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
After you connected the effect to the mains, the LED PST-4W QCL Spot starts running.
With the program select button on the rear of the device you can choose the desired program.
Program 1
Switching colors in 10 second intervals
Program 2
Switching colors in 5 second intervals
Program 3
Switching colors in 2 second intervals
Program 4
Red
Program 5
Green
Program 6
Blue
Program 7
White
Program 8
Red and blue
Program 9
Red and white
Program 10
Green and blue
