00068870.DOC, Version 1.0
24/27
Auto Mode
In Auto Mode, the chasers are called up automatically in a continuous loop.
Press the MODE button to select the AUTO mode.
Press the ENTER button to select the desired frequency of the loops.
The desired frequency of the loops (Frequency = FQN 01-99) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm and to exit the AUTO Mode.
Master/Slave Mode
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.
Sound Control Mode
Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity and frequency of the loops, respectively.
The desired sensitivity (SENS 00-31) can be selected via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the SOUND Mode.
Invert function
In this mode, you can change the chaser direction, from left to right or from right to left.
Press the MODE button to select the FLOW INVERT function.
Press the ENTER button. Press the UP or DOWN button to select ON or OFF. This will change the flow
direction.
Please press the ENTER button to confirm and to exit the Mode.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PMB-4 COB RGB 30W Bar will respond to the controller.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
Controlling:
After having addressed the LED PMB-4 COB RGB 30W Bar, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
