00122172.DOCX, Version 1.0
36/52
Mounting via TV spigot on a lighting stand
1
First, loosen the fixation screws at the stand’s
levelling feet. Pull out the levelling feet until the
cross struts and the levelling feet form a 90°
angle. Now retighten the fixation screws.
2
Attach the supplied TV spigot to the LED bar and
tighten.
3
Attach the LED bar with the attached TV spigot to
the upper end of the stand and tighten the locking
screw.
4
Carefully extend the stand.
5
Caution! The maximum load must never be
exceeded. The stand must stand firmly on the
ground. Make sure that all fixation screws are
firmly tightened.
6
After installation, the device requires inspections
periodically to prevent corrosion, deformation and
loosening.
Please note, that the two LED bars may not be
mounted on top of each other. For safety reasons,
it is forbidden to mount the bars on a stand using
TV spigots and TV spigot mounting supports
.
Mounting via mounting brackets
For horizontal positioning and horizontal overhead installation, the enclosed
mounting brackets, washers and knurled screws are to be used. Attach a mounting
bracket to each end of the LED bar using a knurled screw and washer.
Mounting via Mounting Adapters
The LED bars can be attached vertically to a truss or other suitable structure using
the two mounting adapters supplied, or using suitable hooks or clamps. To proceed,
attach one mounting adapter to each end of each bar.
Please, under no circumstances, mount the LED bars horizontally!
Please note, that for overhead installation, the two bars may not be installed next to or one below the
other. For safety reasons, overhead installation of the bars connected by TV spigots and TV spigot
mounting supports is prohibited!
Содержание LED Pixel Tower
