00119979, Version 1.1
16/20
OPERATION
After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board and in DMX-controlled mode via any commercial DMX controller.
Menu structure in s
tand-alone mode
Mode
Display
Function
DMX mode
d001
d001-512
DMX starting address
Automatic mode
P000
P000 – P255
Color change, “Switching”, with
increasing speed
L000
L000 – L255
Color change, “Fading”, with
increasing speed
E000
E000 – E255
Color change, “Pulsing”, with
increasing speed
Sound control
SOUd
Sound control
Color mix with Dimmer
r000
r000-255
Red 0-100%
g000
g000-255
Green 0-100%
b000
b000-255
Blue 0-100%
u000
u000-255
White 0-100%
Strobe
F000
F000-F255
Strobe effect, with increasing speed
DMX OPERATION
Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 7 control channels. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller’s documentation.
1 Press the
MENU
button so many times until
d001
is indicated in the display. Confirm with the
ENTER
button.
2 Use the buttons
UP
and
DOWN
to set the address. Confirm with the
ENTER
button.
3 A dot will flash in the display when DMX signals are being received. If no control signals are available,
the dot will not flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.