00054241.DOC, Version 1.2
23/31
4. MOUNTING
4.1 Mounting on a stand
For mobile use place the light set on a lighting stand. Suitable items can be found in chapter Accessories.
1. On the stand, the fixation screws of the legs. Pull out the legs until the cross struts stand at a 90° angle
to the legs. Tighten the fixation screws of the legs.
2. Attach the light set via its TV pin on the control unit to the top end of the stand and fasten the fixation
screw.
3. Caution! The load has to be installed in a balanced way. The carrying capacity of the stand must never
be exceeded. The stand must be set up in a stable way. Make sure all fixation screws fit tight.
4.2 Fixing to a truss
The light set can be fixed to a truss using two C-hooks with M10 screw.
1. In each case, put the head of an M10 screw to the upper side of the control unit and, together with the C-
hooks, screw them down at the extreme ends of the control unit, if possible.
2. Suspend the C-hooks in the truss and tighten the fixation screws.
3. Always install a safety bond. Before rigging, make sure that the installation area can hold a minimum
point load of 10 times the device's weight.
4.3 Rearranging the spots
If required, the spots can be rearranged to the upper side of the control unit. For this loosen the fixations
screws on the lower side so that the spots can be removed. Then loosen the fixation screws on the upper
side, rearrange the spots and tighten all fixation screws.
4.4 Safety instructions
For overhead rigging in public or industrial areas, a series of safety instructions have to be followed that this
manual can only give in part. The operator must therefore inform himself on the current safety instructions
and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
DANGER TO LIFE!
Please consider the
and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
DIN 15560-27
