00062991.DOC, Version 1.2
13/16
IN
OUT
INSTALLATION
Attachment
Attention: Permanent installation is recommended!
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
Please note:
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1:
The hole for the installation is on the mounting bracket.
Step 2:
Hold the mounting bracket onto the location where the device is to be installed.
Step 3:
Mark the borehole with a pen or a suitable tool.
Step 4:
Drill the hole.
Step 5:
Hold the mounting bracket in the desired position and fix it.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Controlling
The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
The IR receiving signal cable must be connected to the
first device in series (IN socket).
