00048186.DOC, Version 1.1
14/16
Flash Mode
Set DIP Switch 9 and 1 to ON to obtain the fastest flash effect.
You can adjust the flashing speed by using DIP switches 4, 5, or 6: 4 is slow, 4 and 5 is slower, 4, 5 and 6 is
slowest.
Fade Mode
Set DIP Switch 9, 1 and 3 to ON to obtain RED-GREEN-BLUE fading effect.
Set DIP Switch 9, and 3 to ON to obtain RED-GREEN fading effect.
Set DIP Switch 9, 2 and 3 to ON to obtain RED-BLUE fading effect.
Set DIP Switch 9, 1, 2 and 3 to ON to obtain BLUE-GREEN fading effect.
Blackout
Set all DIP switches to OFF.
Sound Controlled Mode
Set DIP switch 8 to ON to run the internal program via sound control.
DMX-CONTROLLED OPERATION
You can control the spots individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
For DMX-controlled operation set DIP Switch 10 to ON.
Addressing
Each device occupies 4 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Device 1 - channels 1-4
On
Off
DMX-starting
address
Projector number
& channels
Off
Device 2 - channels 5-8
On
Off
Device 3 - channels 9-12
On
Off
Device 4 - channels 13-16
On
Off
Device 5 - channels 17-20
On
Off
1
2
4
8
16
32 64 128 256
DIP-switch no.
1
2
3
4
5
6
7
8
9
Setting the DMX-
starting address:
