00048186.DOC, Version 1.1
13/16
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution:
At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Master/Slave-Operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the FIB-207 or FIB-450 LED Fiber Light RGB DMX you can find an XLR-jack and an
XLR-plug, which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a stereo shielded cable. Connect
the OUT-jack with the IN-plug of the next device.
Set DIP Switch 10 to OFF in order to determine the Master device. Set DIP Switch 10 to ON and DIP
switches 1 - 9 to OFF in order to determine the Slave device(s).
Connection with the mains
Connect the connection cable of the power unit to the power supply jack. Plug the power unit into your outlet.
After you connected the device to the mains, the FIB-207 or FIB-450 LED Fiber Light RGB DMX starts
running.
OPERATION
The device has two operating modes. It can be operated via DIP Switches or it can be run in DMX-controlled
mode.
OPERATION VIA DIP SWITCHES
Static Mode
In order to select static RED, set DIP switch 1 and 2 to ON (1 for very bright, 2 for medium bright)
In order to select static GREEN, set DIP switch 3 and 4 to ON (3 for very bright, 4 for medium bright)
In order to select static BLUE, set DIP switch 5 and 6 to ON (5 for very bright, 6 for medium bright)
To select static color combinations, set the DIP switches of your choice to ON (1,3,5 for very bright; 2,4,6 for
medium bright).
Color Change Mode
Set DIP Switch 9 to ON to obtain the fastest RGB color change effect.
You can adjust the changing speed by using DIP switches 4, 5, or 6: 4 is slow, 4 and 5 is slower, 4, 5 and 6
is slowest.
