00057405, Version 2.1
7/8
OPERATING DETERMINATIONS
This device was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
You can install the device at any desired place in dry rooms. Please make sure that the device is not exposed
to extreme heat, moisture or dust. There should not be any cables lying around. You endanger your own and
the safety of others!
Operate the device only after having familiarized with its functions. Do not allow an operation by persons who
do not know the device well enough. Most damages are the result of an unprofessional operation!
Please consider that for safety reasons unauthorized modifications to the device are forbidden!
INSTALLATION
Installing the Color wheel
Procedure:
Step 1
: Loosen the nut and the first ring gear of the mounting axis on the color wheel.
Step 2
: Remove the plastic wrapping of the color wheel.
Step 3
: Place the wheel on the mounting axis of the motor.
Step 4
: First place the ring gear and then the nut onto the mounting axis.
Step 5
: Tighten the nut firmly without damaging the color wheel.
Step 6
: Attach the color wheel with motor to the housing of the Pinspot and tighten the screw firmly.
Connection with the mains
Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green Earth
Attention!
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The
device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connect the device to the mains, it starts running.
CLEANING AND MAINTENANCE
