00081934, Version 1.0
24/30
The earth has to be connected! If the device will be directly connected with the local power supply network, a
disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent
electrical installation. The device must only be connected with an electric installation carried out in
compliance with the IEC standards. The electric installation must be equipped with a Residual Current
Device (RCD) with a maximum fault current of 30 mA.
Rechargeable battery operation
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged for 24
hours.
1
Switch on the device with the power switch. The operating time of the battery depends on the operating
mode, e.g. up to 6.5 hours when all LEDs constantly light at maximum brightness and up to 20 hours
when a single color lights. After the operation, switch the device off.
2
For charging the battery, connect the device to a power outlet via the enclosed power cable. The lower
indicator lights up red (charging active). When the battery is fully loaded, the upper indicator lights up
green.
3
Charging time is 5 hours. The device may be operated during the charging procedure.
4
The device features a protective circuit for charging which prevents overload of the rechargeable
battery. However, disconnect the device from the mains after charging. Otherwise there will be a low
current consumption even if the device is switched off.
5
To prevent damage to the battery by deep discharge, recharge a completely discharged battery as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Battery status
30 seconds after the last actuation of a button, the display indicates the battery charging status by four bars
(see graphic). If all four bars are displayed, the battery is fully loaded. If the display is flashing, the battery is
going flat. In this state, the device can be operated for another 20 to 30 minutes. Then an emergency switch-
off deactivates the device to protect it from total discharge.
OPERATION
Switch on the device with the power switch. The unit requires a short initialization process and is then ready
for operation. The display shortly inserts the firmware version and you can choose the desired mode via the
buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or the
remote control or in DMX-controlled mode via a standard DMX controller.
8888
8888
8888
8888
100%
75%
50%
25%
