00124081, Version 2.2
16/20
INSTALLATION
Installing/replacing the illuminant
DANGER! Electric shock caused by high voltages
Within the device there are areas where high voltages may be present. Always disconnect the
device from the mains socket prior to installing or replacing a lamp. Mount the cover and attach it
firmly before connecting the device again.
WARNING!
Risk of burns at the surface and in case of inappropriate handling of the
illuminant
The device and the illuminant become very hot during operation. Let the device cool down for at
least 20 minutes before replacing the illuminant.
The device is supplied without illuminant. The matching illuminant types are indicated in the “Accessories”
section. Do not install illuminants with a higher wattage! Illuminants with a higher wattage generate
temperatures the device was not designed for. Damages caused by non-observance are not subject to
warranty. Observe the safety instructions of the illuminant manufacturer.
Procedure:
Step 1:
Make sure that the device is turned off, disconnected from the mains and completely cooled
down.
Step 2:
Unscrew the lamp cover.
Step 3:
If replacing the lamp, remove the old lamp from the housing and loosen the screws and wires.
Step 4:
Connect the wires with the new lamp and tighten the screws. Avoid touching the glass blub bare-
handed.
Step 5:
Insert the lamp in the housing and screw the lamp cover back on.
Step 6:
Only reconnect the device to the mains after the front cover has been closed and securely fixed.
Rigging
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging
freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the “Accessories” section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate eyelet is mounted on the device for fixation of the safety rope. Fasten the safety rope in such
a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
5
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and tighten the fixation screws.
6
After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.