Assembly
11
Quick installation guide_Conveyor system EURO-flex Al_20221111_EN.docx
3. Clip slide rail to the profile with the nose on the underside
(see Figure).
4. Clip slide rail to the profile in the running direction with the
assembly tool.
ǃ
Avoid the development of “waves” in the slide rail by
clipping it on completely (audibly).
ǃ
Avoid slide rail connections at the connection points of
the guide profiles.
5. In the case of slide rail connections, cut both slide rail ends
with the mitre cutter at an angle of approx. 45°. Gently deburr
the butt ends.
6. Cut back the start of the new slide rail section with a narrow
angle (running direction, see arrow). Gently deburr the butt
ends.
7. Maintain a distance of approx. 10 mm between the slide rail
ends (running direction, see arrow).
8. Do not position two slide rail connections so that they are
opposite each other. Maintain a minimum spacing of
approx.100 mm.
9. Each slide rail section must be double fixed at the start
(viewed in the running direction), see
“Fixing slide rail”.
Slide rail before the bending wheel:
10. Cut off the end of the slide rail with an angle of approx. 45°
with the mitre cutter.
ǃ
The slide rail must be slightly longer than the guide
profile.
ǃ
A distance of 10 mm must be maintained between the
end of the slide rail and the bending wheel.
ǃ
The end of the slide rail may not curve upwards or
downwards.