Modules
7 - 4 Setting Up SATA RAID or AHCI Mode
7
SATA RAID Setup Procedure (Windows 8.1)
To configure your RAID (Redundant Array of Independent Disks) system in Strip-
ing (RAID 0) or Mirroring (RAID 1) modes (see
) you will
require
at least
two
identical
(see sidebar) hard disks.
Note that the RAID setup in
Windows 8.1
differs from that outlined for
Windows7
.
You need to setup a RAID before installing your
Windows 8.1
operating system, and
you will need to prepare the following in order to do so.
1.
The
Microsoft Windows 8.1 OS DVD
.
2.
A hard disk installed in the Primary HDD bay.
3.
A
second
(identical) hard disk installed in the Secondary HDD bay.
4.
The
Device Drivers & Uti User’s Manual
disc.
5.
A USB flash drive.
6.
An operable computer (to copy files from the
Device Drivers & Uti User’s
Manual
disc to the USB flash drive).
Before setting up the system you will need to copy a driver folder to a USB flash
drive or external USB hard disk. This driver folder is included on the
Device Drivers
& Uti User’s Manual disc
but
you will need to go to an operable computer
and copy the folder to a USB Flash drive or external USB hard disk.
Содержание NEPTUNE 4
