Euro-Pro Shark 7133, Инструкция по эксплуатации, Страница: 57 / 107

GB
Sewing on buttons
48
2
3
1
a
b
B
a b
a
b
0
1
2
3
4
S
0
3~5
5
0
1
2
3
4
Move the drop feed control to right side to lower the feed dogs. (1)
Change presser foot to button sewing foot.
Position the work under the foot. Place the button in the desired
position, lower the foot. Set the pattern selector knob on zig zag
stitch "
". Adjust the stitch width to "3" - "5" according to the
distance between the two holes of the button. Turn the handwheel
to check that the needle goes cleanly into the left and right holes
of the button. Set the pattern selector knob on straight stitch " ",
and sew a few securing stitches. Set the pattern selector knob on
zig zag stitch "
", and slowly sew on the button with about 10
stitches. Set the pattern selector knob on straight stitch " ", and
sew a few securing stitches. (2)
If a shank is required, place a darning needle on top of the button
and sew. (3) For buttons with 4 holes, sew through the front two
holes first (2), push work forward and then sew through the back
two holes. (3)