www.eurenergroup.com
Please read this manual carefully before installation and keep it for future
reference.
INTRODUCTION
» Polycrystaline and Monocrystaline Eurener Photovoltaic (PEPV/MEPV) modules consist of crystalline silicon solar
cells, high transmission and low iron toughened glass, anti-aging EVA and high flame resistant back sheet and
anodized aluminum alloy frame.
» PEPV/MEPV modules are qualified for national standard IEC 61215.2 and IEC 61730, which have passed
examination of the authorized test center. The manufacturer modules can be used in roof solar systems, PV stations,
communication stations, petrol, ocean, meteorological, traffic and PV buildings etc.
» We are committed to providing technical and installation support for our customers worldwide.
» This Installation Manual is applicable to the installation of the following PEPV/MEPV modules:
MEPV***/ MEPV***-B
PEPV*** / PEPV***-B
Notes: 1. MEPV*** and PEPV*** is used here as an example.
2.
“***” is the rated power of the related manufacturer module.
» This manual contains important information regarding the installation, safe handling and maintenance of PV modules
made by the manufacturer.
» All instructions should be read and understood prior to installing the modules. The installer should conform to all
requirements in this manual. The appropriate local standards and regulations, construction rules and safety
instructions should also be followed during installation. All work on a PV system must be carried out by appropriately
qualified engineers, who must be familiar with the mechanical and electrical requirements for such a PV system.
DISCLAIMER OF LIABILITY
» The installation, handling and use of PEPV/MEPV modules are beyond company control. Therefore, the manufacturer
assumes no responsibility for loss, damage, injury or expense resulting from improper installation, handling, use or
maintenance.
» The manufacturer reserves the right to update the product, specifications or this Installation Manual without prior
notice.
1) CERTIFICATES REQUESTS
1.1) IEC 61730
» EURENER modules are designed to fulfill the criteria of Application class A requirements according to IEC 61730-1.
» Modules rated for use in application class A may be used in systems operating at greater than 50V DC or 240W,
where general contact access is anticipated. Modules qualified for safety through IEC 61730-1 and IEC 61730-2 within
application class A are considered to meet the requirements for safety class
2) INSTALLATION REQUIREMENTS
2.1) INSTALLATION ENVIRONMENT REQUIREMENTS
Avoid shading:
» Even if the smallest local shelter/shadow (such as dust deposition) will also decrease the output power.