C
D
Roof poles
Wall poles
green
blue
fig 12
Component List:
1 Screen Body with Plastic Elbows and Guy Ropes,
4 Wall Poles, 2 Roof Poles, 1 Carry Bag, 1 Stake Bag and Stakes, 1 Pole Bag
2.
Assemble the shock
corded poles
and divide
according to size and shape. Take
care; make sure that each pole
section is fully seated into the
next. Do not allow the sections to
snap together as this can damage
the ends. See fig 2.
1.
Remove from the carry bag
and separate all the components. Unroll and
unfold the fabric top side up, on a clean dry space and open the doors. If windy, stake
down the windward corner. See fig 1. This is a large structure; it is best to assemble it
with two people.
ASSEMBLY INSTRUCTIONS
For the N!ergy Screen House
A
B
fig 2
fig 1
fig 5
fig 3
fig 6
fig 7
fig 8
fig 9
fig 10
fig 4
3.
Insert both roof poles
into the sleeves sewn on the tent body. They should run
corner to corner crossing in the center. The top pole should also pass through the center
loop. See fig 3.
Fit one end of each pole into a nylon elbow attached to the roof corners at
A
and
B
. Move to
the opposite side, arch the poles and again fit into the nylon elbows at
C
and
D
. See fig 4
and 5.
REV. B 4.09
fig 11
E! Power System:
To use, you will need a power source. Our
E! Power Pak™
is
sold separately. Once connected to power, the control will display “green” at any
switch that is “ON” and the “ON” socket will glow blue. See fig 12.
Accessories: E! Power Fan/Light, E! Power Reading Light and an E! Power
12v Adapter Cord.
Take Down:
Pull up all stakes.
Remove clips from tent poles and
pull poles off of the pins. Remove
poles from the top. Collapse all
poles and stow. Fold the tent onto
itself then roll up and stow.
Guy Out:
This structure has very
large straight walls that act
differently in high winds. Should high winds occure, carefully follow the guy out
instructions on the back side of this sheet. Reflective guylines are pre-attached.
Raise the battery pack up off of the floor during rain. Read the other
important safety instructions on the reverse side.
7.
Tuck the ground skirt
under the walls and
into the shelter. See fig 11.
Your Shelter
is Ready!
6.
Stake the shelter down.
Stake through the
corner web loops, not the corner rings. Stake
opposite corners while applying tension to
smooth the sidewall wrinkles. See fig 10.
Note:
There are snaps on the wall panels just
below the zippers. Be sure to secure these
snaps before you square and stake the shelter.
The snaps will keep the wall panels together
when you raise and lower the zipper and will
keep tension off of the zipper when you pull the
sidewalls to smooth.
5. Attach all clips t
o
the wall poles. See fig 9.
4. Raise the tent.
Lift the
top poles to form a dome.
Start on one side and
insert the wall poles into
the elbows. See fig 6.
At the bottom of each pole,
insert the pin/ring
(attached to the corner
web) into the bottom of each pole. See fig 7
& 8. Repeat on the other side until the
shelter is at full height and freestanding.
Note:
With the last pole, it is usually easier if
you first fit the bottom pin into the pole and
then fit the elbow.
Take care: You must keep the top
“up” when you insert the walll poles
