Eureka E51 BASE, Инструкция по эксплуатации

Страница: 23 / 37

24
REPLACING THE FRONT BLADE
Follow the instructions below to replace the front blade :

Remove the squeegee (see position 1) from the machine;

Use a 10-mm tubular nut driver (see position 2) and remove the 6 screws (see position 3) and the respective washers
(see position 4);

Remove the blade locking plate (see position 5);

Remove the blade (see position 6);

Rotate the blade and mount it back so that a new edge is on the drying side of the blade;

Put the blade locking plate (see position 5) back into place;

Put the 6 screws back into place (see position 3), including the respective washers (see position 4) and make sure not
to tighten the screws excessively causing the rubber blade to deform (swell).
CHECKING THE INSTALLATION OF THE SQUEEGEE BLADES
1
2
Once the squeegee blades are rotated or replaced, lay the squeegee onto a flat surface and check the following:

Make sure the rear blade (see position 2) is fitted correctly and levelled throughout its entire length. If the blade is not
fitted evenly, release the blade locking plate and re-position the blade so that it is levelled correctly against the floor.

Make sure the front blade (see position 1) is fitted evenly and check for any deformations due to tightening the screws
excessively. Also make sure the blade is raised 3 mm above the ground throughout its entire length.