Locator
Ta
Up
User Controls
Charging Jacks
•
Batteries are fully charged in 3 hours.
•
Tag battery will run 3 months in
monitor, 1 month in standby and 3 days
in track.
•
Locator will run 8 hours in search, 3
days in track or 4 days in monitor.
•
Locator may be kept connected to
charger for continuous monitoring.
Charging
Select
Power
Button
Status
Light
Pet
Buttons
1 2 3
Power
Button
Tag
Powering On the Locator
•
Press and hold the power button until the display
comes on and the locator beeps twice.
•
If the locator will not power on then connect the
charger and try again.
•
Short presses of the power button turn the display
backlight on and off.
Powering On the Tag
•
Press and hold the power button. The status light with
flash in 3 groups of 1 two or 3 flashes. 3 = Fully
charged battery; 2 = half charged; 1= needs charging.
•
Press and hold the power button to turn off. 1 second
flash means tag is turning off. Short flash means tag
was busy communicating, try again.
Down
Searching for a Lost Pet
•
Press the Pet button 1, 2
or 3 for the desired pet.
•
“Track” will flash, press
Select to start searching.
•
“Searching” will now
flash at the top of the
display.
•
To stop the tracking
operation, press the Pet
button repeatedly until
the mode box is blank
and then press Select.
Searching Tips
•
If the locator loses contact
with your pet’s tag then “No
Signal” will be displayed.
•
If a direction can not be
computed “Change Location”
will be displayed.
•
These messages may pop up
occasionally in normal
operation.
•
If the signal is lost for 40 sec
then the searching mode will
restart automatically.
•
Always hold the locator
level to the ground, waist
high in front of you.
•
To get a directional arrow,
move to an unobstructed area,
higher ground is better.
•
When you first get a
directional arrow turn 90
degrees and see if the arrow
tracks.
•
Always point the locator in
the direction of the tag while
moving, not away from it.
•
If the arrow is lost or jumps in
direction continue on in the
last known direction.
•
If no arrow is displayed, use
the distance indication in a
“warmer/colder” fashion until
the direction is shown.
•
Search by driving or walking
when no signal is received.
•
Pressing Down for 2 seconds
silences the beeper.
Selecting the Pet
Mode Box
Flashing
Searching
Flashing
Range %
Range Bars
Direction
Arrow
•
A single beep indicates the
tag has begun responding to
the locator’s searching
signals.
•
If after 2 minutes the pet’s
tag has not responded a long
beep will sound and “No
Signal” will be displayed.
•
Press Select to restart search
mode again, walk or drive
to likely areas where your
•
Each time your pet’s tag
responds the locator will
beep, about every 4 seconds.
•
1 beep = far, 2 beeps =
closer, 3 beeps = nearby
•
The range bars and distance
percentage indicate the
proximity of the pet.
•
More bars = closer
•
Higher percentage = closer
•
The directional arrow shows
the direction to your pet.
Quick Reference Guide
Tracking Error
Messages
