EURA SD20-G Series, Руководство пользователя

Страница: 344 / 353

SD20-G Series
344
01 06 00 6D 00 05 D8 14
Servo1 write register Po109 5(Unit: ms) CRC check
Slave response:
Address Function
Register
Address Hi
Register
Address Lo
Write status Hi Write status Lo
CRC Lo CRC Hi
01 06 00 6D 00 05 D8 14
Servo 1 write register Po109 5(Unit: ms) CRC check
(2) In RTU mode, read acc time (Po109) of No. 01 servo drive.
Host query:
Address Function
First
register Hi
First
register Lo
Numbers of
register Hi
Numbers of
register Lo
CRC Lo CRC Hi
01 03 00 6D 00 01 15 D7
Servo1 read register Po109 one register CRC check
Slave response:
Address Function Data numbers Data Hi Data Lo CRC Lo CRC Hi
01 03 02 00 C8 B9 D2
Servo 1 write register 2 bits 200(Unit: ms) CRC check
10.1.3 Parameter related to communication
Function
Code
Function Definition Setting Range Setting unit
Mfr’s value
Remarks
Po500
Communication
address
1~254
—
1
Po501 Communication mode 0~1
—
0 0
：
RTU 1
：
ASCII
Po502 Stop bit 0~1
—
0 0: 1bit 1: 2 bits
Po503 Parity check selection 0~2
—
0
0: No checkout
1: Odd 2: Even
Po504 Baud rate 0~5 bit/s 2
0: 2400 1: 4800
2: 9600 3: 19200
4: 38400 5: 57600
Note: Please set functions code related to communication consonant with the PLC/PC communication
parameters, when inverter communicates with PLC/PC.
The command from PC will be written into data memory of servodrive Immediate, it is not good to write the data
into the memory continuously.
Permission of Read&Write:
Parameter Remarks
Po505
0
Permission of Read &Write, the communication data is allowed to be written into data
register.
1
Prohibition of Read&Write, the communication commands are only executed, but they are
not allowed to be written into data register. If the servodrive is power off, data will be lost
and they need to be written again.
2 Structure of Field Bus