EUCHNER 123592, Руководство по эксплуатации

Страница: 12 / 20

Operating Instructions
Key Adapter CKS-K-AS2A-U-C20-PC
12
(translation of the original operating instructions) 123914-01-05/15
10. System status table
Operating mode
Key inser
ted
CKS LED indicator
State
Gr
een
Yellow Red
Normal operation
Yes Normal operation, key inserted
No 1 x Normal operation, no key taught-in
No Normal operation, no key inserted AS-i bus connected and in operation
Yes 1 Hz Normal operation, key inserted but not taught-in, AS-i bus connected and in operation
Teach-in standby No 3 x Device is ready for teach-in of another key (only short time after power-up)
Setup
Yes 1 Hz Teach-in operation
X
Positive acknowledgment after completion of teach-in operation or device not connect-
ed
Fault display
Yes 3 x Defective key (e.g. fault in code or code cannot be read)
X Internal fault (e.g. component faulty, data error)
X 4 x Error: AS bus connected, no communication with the master
Key to symbols
LED not illuminated
LED illuminated
10 Hz (8 s) LED flashes for 8 seconds at 10 Hz
3 x LED flashes three times, and this is then repeated
X Any state
After the cause has been remedied, faults can generally be reset by removing and inserting again the key. If the fault is still
displayed afterward, briefly interrupt the power supply. Please contact the manufacturer if the fault could not be reset after
restarting.
Important!
If you do not find the displayed device status in the System status table, this indicates an internal
device fault. In this case, you should contact the manufacturer.