PACKAGE CONTENTS
Part Description
Quantity
A
Lens
1
B
Fixture Base
1
AA
Drywall Anchors
4
BB
Wire Nut
2
CC
Fix Screw (for mounting)
4
DD
Fix Screw (for J-box)
2
EE
Gasket
1
USE AND CARE GUIDE
9” RECTANGULAR MARINE BULKHEAD WITH COLOR PREFERENCE
®
AND LUMEN BOOST
TM
NOTE
:
Keep your receipt and these instructions for proof of purchase.
WARNING
:
Shut off the power at the circuit breaker or fuse panel before removing the old fixture, ballast, or fluorescent tubes.
NOTE
:
Stick the replacement label on the inner wall of the recessed housing before installation.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
INSTALLATION 1
1
Open the lens (A) from the fixture base (B) by screwdriver, and disconnect
the connector between PCB and the driver.
2a
Mark 4 holes position and drill holes using
Φ
0.26in.(6.5mm), insert the
drywall anchors (AA) into the holes.
NOTE
:
Do not need drill holes on wooden surfaces.
3a
Put the Gasket (EE) on the back of fixture base (B). Drill 4 holes through the 4
markpoints of fixture base (B), connect the AC wires and the driver wires by
wire nut (BB).
NOTE
:
AC wires should go through one of the 5 conduit entry holes on
the fixture base (B).
4a
Align the holes on the fixture base (B) with the holes in the wall, and drill fix
screws (CC) into the holes, lastly, silicone sealant (not included) around the 4 holes.
Assemble the lens (A) with the fixture base (B) after connecting the connector of
PCB and driver. Then tighten with lens screws. Apply silicone sealant (not included)
between the fixture and the wall.
Model # 504091120
Part # MBRT-9IN-2LB-8-3CP-MV-WT
A
B
AA
BB
CC
DD
EE
A
B
Connector
7.48in. (190mm)
4.33in. (110mm)
AA
Φ
0.26in. (6.5mm)
Conduit entry holes
Mark points
Conduit
(not included)
BB
B
EE
Φ
0.18in. (4.5mm)
B
B
CC
Lens screw
Silicone sealant
(not included)
A
Connector
