Etesia AH75, Оригинальное руководство пользователя, Страница: 19 / 26

19
9• LONG STOP - WINTER STORAGE
PREPARATION
• Start by cleaning carefully the brush-cutter particularly under the
cutting deck.
• To avoid sediment, completely empty the fuel from the tank and,
open the fuel tap and empty the fuel in the carburettor tank by uns-
crewing the emptying screw or by leaving the engine running until
it becomes empty.
The tank emptying has to be done outdoors.
Don’t smoke.
• Disconnect the spark top.
• Engine hot, empty the oil frame. Fill with new oil until you reach
the FULL mark for the AK60 model and the upper limit of the
gauge for the AH75 model.
• Proceed to cleaning the air filter.
• Remove the spark and oil the cylinder with a spoonful of oil. Pull
the starter several times to distribute the oil and protect the cylinder
and valves from corrosion.
• Put the spark plug back.
• To prevent rust from forming, close the engine valves by pulling
gently on the starter handle until you feel some compression.
• Before you put the machine back into place, cool the machine then
drive it into a dry place on a shelf or a sheet of metal.
To reduce the risk of fire, store the machine in place free of
grass, leaves and grease and far from any ignition spark.
• Of course you may leave this seasonal maintenance work to your
ETESIA dealer if you wish. He will check that your brush-cutter is
in good condition...so that it starts first go the following spring.
TO PUT IT BACK TO SERVICE
• Proceed as follows :
- Unscrew the spark and clean it with fuel. Allow to dry without
replacing it.
- Pull energetically several times on the starter cord to eliminate
oil excess from the cylinder.
- Refit the spark plug.
- Check the oil level and tank with unleaded fuel.
- Open the petrol tap before starting the engine.
• This seasonal maintenance can of course be done by your ETESIA
dealer.