Pack contents:
PIR lantern x 1
Fixing kit x 1
Model:
PIRL60BK / PIRL60WH
Full Lantern with 110
°
PIR
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION
AND RETAIN FOR FUTURE REFERENCE
INSTALLATION INSTRUCTIONS
A guide for qualified electricians
874/2012
MODELNO.
PIRL60BK / WH
CLEANING:
To avoid dust build-up and ensure proper
functioning of the bulkhead light, please wipe
the sensor lens lightly with a damp cloth every 3
months.
Disconnect the power and clean the exterior only of
this fitting with a moist (not wet) cloth.
Do not use any chemical or abrasive cleaners.
LAMP REPLACEMENT:
• Switch off the electricity at the mains.
• Release top cover by removing the two screws
• Remove and replace lamp making sure it seats
correctly in the lampholder
• Replace and secure cover
• Restore power
REPLACEMENT LAMP TYPE:
Requires 1 x suitable ES energy saving lamp
Wattage:
Fitting is rated at 60W max
Supply Voltage:
230V
Type:
E27
Note: do not fit reflector lamps (spotlight or crown
reflector)
PG 1
PG 6
Issue 2015
FOR PRODUCT ADVICE:
• T: 01933 673 144
• F: 01933 678 083
• E: [email protected]
Visit our website:
www.eterna-lighting.co.uk
Made in China
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
“WEEE Directive” effective August 2005—UK
WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/
GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST - DO NOT
DISPOSE WITH HOUSEHOLD WASTE.
IF YOU EXPERIENCE PROBLEMS:
If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any Eterna Lighting
product, but may not be able to give specific
instructions regarding individual installations.
For breakage information visit:
www.eterna-lighting.co.uk
