ETC SealerAtor, Руководство пользователя

Страница: 15 / 20

Operation 11
Personality Menu
Use the Personality menu to select the profile of the fixture you need to test, set the default
display units, and access the service settings.
Select the Fixture
Navigate: Main Menu → Personality → Fixture
Select the profile of the fixture you want to test from the profiles that have been uploaded to
the SealerAtor.
1. Press the right and left navigation buttons to locate the fixture to be tested.
2. Press the Enter button. The fixture's profile is shown.
3. Press the Enter button again to select the fixture.
Set the Display Units
Set the units of pressure.
•
kPa
•
psi
Access Service Settings
Navigate: Main Menu → Personality → Service Setting
Menu Item Values Description
Password Service Password You must enter the service password in order to access the
other service settings. The default service PIN is 050. Use the
left and right navigation buttons to change the password.
Set Fixture
•
Available
Fixtures and
Settings
•
Delete Fixture
View and change the pressure, vacuum, and hold time values
used during testing, or delete a fixture from the SealerAtor.
The test values displayed are predefined for the fixture. ETC
recommends that you do not change the values.
The Delete Fixture option is shown at the bottom of the list
of a fixture's pressure, vacuum, and hold time values. To
delete the fixture:
1. Press the down navigation button until Delete Fixture is
highlighted.
2. Press the right navigation button to select Yes, and then
press the Enter button to delete the fixture.
Reset
Default
•
ON
•
OFF
Return the SealerAtor to its default factory settings.
Info Menu
Access the Info menu to view information about the SealerAtor.
View Software Version
Navigate: Main Menu → Info → Software Ver
Displays the software version installed on the SealerAtor.