ETC Setup Guide
Two-Port Gateway
Two-Port Gateway
Page 7 of 8
ETC
Configure Port Settings
1.
From the Home screen, select Setup > Ports.
2.
Use the Enter button to move from the menu options on the left to the values on the right side
of the screen. Use the Up and Down buttons to change the values and press Enter again to
confirm the change. Using these controls, configure the fields on screen:
•
Port - Select the port for which the following values apply:
•
Mode - Select the port mode. This can be set to Input, Output or Disabled.
•
Universe - Select the Universe of the port (1-63999).
•
Speed - Select the speed at which DMX is transmitted. This can be set to Slow, Medium, Fast,
and Max.
Note:
For detailed DMX speed timings, visit:
https://support.etcconnect.com/ETC/FAQ/DMX_Speed
.
Configure RDM Settings
1.
From the Home screen, select Setup > RDM.
2.
Use the Enter button to move from the menu options on the left to the values on the right side
of the screen. Use the Up and Down buttons to change the values and press Enter again to
confirm the change. Using these controls, configure the fields on screen:
•
Port - Select the port for which the following values apply:
•
RDM - Select whether RDM is enabled or disabled on the port.
•
Background - Select whether background discovery and polling of RDM is on or off.
Configure Data Loss Settings
1.
From the Home screen, select Setup > Data Loss.
2.
Use the Enter button to move from the menu options on the left to the values on the right side
of the screen. Use the Up and Down buttons to change the values and press Enter again to
confirm the change. Using these controls, configure the fields on screen:
•
Port - Select the port for which the following values apply:
•
HLLF - Select whether Hold Last Look Forever (HLLF) is on or off. Selecting On enables Hold
Last Look Forever. Additional configuration options for hold last look are available in Concert.