Install the Heavy Diffusion Accessory
23
Install the Heavy Diffusion Accessory
WARNING:
RISK OF ELECTRIC SHOCK! Failure to disconnect all power to
the fixture before working inside could result in serious injury or death.
Disconnect power from the fixture and follow appropriate Lockout/Tagout
procedures as mandated by NFPA 70E. Any work must comply with
OSHA Safe Working Practices and follow requirements by local code.
AVERTISSEMENT :
RISQUE DE CHOC ÉLECTRIQUE! Travailler à l’intérieur
du luminaire sans avoir déconnecté le courant peut entrainer des blessures
graves, voire mortelles.
Déconnectez l’alimentation du luminaire et suivez les procédures de
Consignation/Déconsignation appropriées prescrites par la norme NFPA 70E.
Tout travail doit être conforme aux consignes de sécurité du travail de
l’OSHA et respecter les codes locaux.
A heavy diffusion (65%) accessory for the Lonestar fixture is available separately for purchase.
The heavy diffusion is installed in place of the prism in the head of the fixture. When the heavy
diffusion is installed, you must use the Trifusion DMX protocol so that the fixture will home
properly. (See
and
for details.)
To purchase the accessory, contact ETC Technical Services or your authorized ETC dealer. See
Help from Technical Services on page 2
for contact information.
Tool needed:
l
#3 Phillips screwdriver
1. Disconnect power to the fixture and allow it to cool completely before continuing.
2. Remove the head cover. You only need to remove the head cover that is on the top of the
fixture when the front lens is facing away from you and the tilt lock is to the right of the
fixture head.
a. Using a #3 Phillips screwdriver, loosen the captured Phillips screws that secure the cover to
the fixture.
b. Lift the cover, and then detach the safety lanyard from the fixture to completely remove
the cover.
