ETC F-Drive W1 Series, Руководство по установке, Страница: 38 / 44

34 W1 Installation Manual
Maintenance
WARNING:
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
power to the system before installation, maintenance, cleaning, or any
other system modification could result in serious injury or death.
AVERTISSEMENT :
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE!
Négliger de débrancher toutes les sources d’alimentation du système avant
l’installation, l’entretien, le nettoyage ou toute autre modification du
système peut causer des blessures graves ou la mort.
De-energize main feed to F-Drive Power Control products and follow
appropriate Lockout/Tagout procedures as mandated by NFPA 70E. It is
important to note that electrical equipment such as breaker panels can
present an arc flash hazard if improperly serviced. This is due to the high
amounts of short-circuit current available on the electrical supply to this
equipment. Any work must comply with OSHA Safe Working Practices.
CAUTION:
RISK OF ELECTRIC SHOCK! Disconnect power before servicing.
ATTENTION :
RISQUE DE CHOC ÉLECTRIQUE! Couper l'alimentation avant
l'entretien.
Emergency Operation and Test
It is important to test W1 Emergency Drivers regularly because they are life safety devices.
NOT SELF-TESTING PER ANSI/NFPA 101 - This equipment is not self-testing in conformance
with the Life Safety Code, ANSI/NFPA 101. ANSI/NFPA 101 Life Safety Code requires testing
of life safety devices every 30 days.
If you are operating a W1 CC Emergency Driver with loads with less than 30 VDC forward
voltage, you must configure the test button. See
Configure the W1 CC Emergency Driver TEST
Button for Low-Voltage Loads on page 26
.
Press and hold the "TEST" button to test the emergency functionality of this device. The test
disables normal control and sets all output circuits to full. During the test, the "DER" LED will
illuminate steady green and the channel LED of any channel at full will illuminate green. If any
channel is operating below full (below 100%) during the test, the "DER" LED will illuminate red.