ETC F-Drive W1 Series, Руководство по установке, Страница: 17 / 44

Chapter 2 13
Install the W1
1 2 3 4
DMX
IN
DMX
THRU
MAINTAIN
B
C D G
H
F
A
E
I
A Removable wiring panel F RJ45 output (not present on W1 CV Driver)
B AC power input G
Two-pin terminal outputs (not present on W1 Chroma
Driver)
C DMX In H SD card
D DMX Thru I Mounting direction arrow
E
DMX termination switch
"DMX_TERM"
Wire power and data (DMX) to the W1 Driver and then run power out to the Navis luminaires or
other loads. If you are installing a W1 Emergency Driver, see
W1 Emergency Driver Installation
on page 23
.
Note:
The W1 Chroma Driver ships with an RJ45 DMX terminator. Navis
RGBW luminaires are not self-terminating. You must terminate the last Navis
RGBW luminaire in line with a 120
Ω
resistor.
To purchase extra RJ45 terminators, please contact your ETC customer service
representative and request part number N4086.