ETC Emphasis Lighting Control System, Руководство пользователя

Страница: 40 / 292

30 Emphasis Console v1.4.0 User Manual
Flexichannel
When you enable Flexichannel, only channels used somewhere in your show will appear
on the Emphasis Console Stage, Blind and Fader displays. By reducing the number of
channels you have to display, you can reduce the amount of paging from screen-to-screen
you need to do to view your data. This, of course, assumes that you are using fewer than
the maximum number of channels in your system, or that your patch places channels all
over the place with numerous gaps between them. If you are using all the available
channels, Flexichannel will only change your display from horizontal to vertical channels.
Which channels are displayed is determined by the following guidelines:
• Flexichannel displays channels with set levels, whether those levels are recorded or
not.
• Flexichannel does not display channels whose channel attributes (see Channel
Attributes, page 54 ) have been changed unless levels are also set.
• Flexichannel displays all channels patched to fixtures.
• Flexichannel displays links to focus points just as you would see in other channel
displays.
• Channels not displayed in Flexichannel displays are shown in gray in Spreadsheet,
Tracksheet and Patch.
Enable or disable Flexichannel:
Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis
Visualization, press [Setup] [1] [Enter] to display the Systems Settings menu.
Step 2: Press [9] [Enter] to access the Flexichannel option.
Step 3: Press [1] [Enter] to enable Flexichannel, or press [0] [Enter] to disable
Flexichannel.
Step 4: Press [Stage] to return to the Stage display.
Working with Flexichannel active will change how you select channels. For information on
channel selection, please see Channel selection in Flexichannel, page 74 .
Expression/Insight display shown.