ETC Emphasis Lighting Control System, Руководство пользователя

Страница: 173 / 292

7
Macros 163
Sample Macros
The following macros are provided as useful samples. There are more macros available at
the ETC website: http://www.etcconnect.com/service/service_macros.asp.
N o t e :
Not all Expression macros are valid for the Emphasis Control System.
Channel Check
[At] [0][0] [+] [Full]
Each time you activate this macro, the next channel is brought to full as the previous
channel is taken out.
Automated Channel Check
[At] [0][0] [+] [Full] [Macro Wait - 5 seconds] [M#]
In this macro, each channel is brought to full for 5 seconds, then the macro repeats itself,
bringing up the next channel. [M#] is the macro’s own number.
Delayed Automated Channel Check
Macro 1: [Macro Wait - 1 minute] [M2]
Macro 2: [At] [0][0] [+] [Full] [Macro Wait - 5 seconds] [M2]
Sometimes you are responsible for doing the channel check and running the console. If you
need to have the automated channel check run, but you also need time to get from the
console to the stage, you can use these two macros to accomplish this task.
Turn Worklights On and Clear the Fader Pairs
[Channel] [ x ] [Full] [Clear - AB] [Clear - CD]
This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D
fader pairs. You can add a range of channels to your selection using the [And] and [Thru]
commands, if needed.
Turn Worklights On and Clear Both Faders and Background Channels
[Channel] [ x ] [Full] [Clear - AB] [Clear - CD] [S3 - Backgrnd Overrides] [Enter] [Enter]
This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D
fader pairs and any background channels. You can add a range of channels to your
selection using the [And] and [Thru] commands, if needed.
Turn Worklights On and Clear All Playbacks
[Channel] [ x ] [Full] [Clear - AB] [Clear - CD] [S3 - Backgrnd Overrides] [Enter] [Enter]
[S1 - Fadeout Subr] [Enter]
This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D
fader pairs, any background channels and any running subroutines on submasters. You
can add a range of channels to your selection using the [And] and [Thru] commands, if
needed.