ETC Element Classic, Руководство пользователя

Страница: 376 / 687

362 Ion Classic User Manual
•
The fader can be set to manual master mode. See
Master (on page 324)
for more
information.
In each of these cases, follow time counts down from [Go]. The hang time will be kicked off
when the fader reaches full or when the last parameter reaches its end state from timing,
whichever comes last.
Note:
The Fader Ribbon and the Fader Display Format of the Playback Status Display
are useful displays when using manual control.
Manual Timing Control
Manual timing can be set for any parameter or group of parameters. A fader is then used to
control the progress of a transition.
Example:
Assume the active cue contains an instruction to set red at 40 for channel 1.
The pending cue contains an instruction to set color for channel 1 to blue and
the color parameter has a manual time. Press [Go] to activate the cue.
Channel 1 color does nothing.
As you move the fader up manually, channel 1 color moves proportionally
from red to blue. Any parameters with timing will start their moves at the
press of [Go] and be unaffected by the manual control.
To program a channel manual time:
•
[1] {Color} [Time] {Manual} [Enter] - assigns a manual time to channel 1. This must be
recorded or updated to a cue, when in Live.
Manual timing can also be set at a cue level:
•
[Record] [Cue] [5] [Time] {Manual} [Enter]
Manual timing can also be set at a cue category level:
•
[Record] [Cue] [6] {Color} [Time] {Manual} [Enter]
Manual Intensity Override
An intensity transition may be taken over manually and the transition captured by dropping
the fader down until it reaches the percentage of cue completion (i.e. if the cue is 50%
complete, when the fader is manually dropped to 50%, the intensity transitions will be
captured and the intensity portion of the cue completed by moving the fader manually
between 50% and full or anywhere in between). If the fader is dropped below 50%, the fader
will fade all intensity values proportionally from their captured values to their previous values.
If a fade is captured and the faders are not reset to 100% prior to the next press of the [Go]
button, the fader will automatically reset to 100% upon cue execution. Alternatively, you can
set the fader to 0% before executing the next cue to capture the cue for manual intensity
control when the [Go] button is pressed if the fader is set to proportional control. Intensity
control is released from the fader when the cue is considered complete (when the fader is
brought back to 100%). If the fader is set as an Intensity Master, the intensity control is
maintained, even when the cue has completed.
If a pending cue has any manual control properties, you may either preset the fader to zero or
the console will automatically set the fader to zero when the [Go] button is pressed.