ETC Echoflex ELED3, Руководство по настройке, Страница: 17 / 24

User Interface 13
Remote Linking Solution
Use the following method to link the first switch if you cannot access the [Learn] button on a
controller that has not been pre-commissioned and you do not have Garibaldi Pro software.
This method only works if there are no switches linked to the controller. You cannot link a
scene station using this method.
1. Ensure you are within wireless range of the controller and have a wireless paddle switch.
a. If the controller has a linked sensor, you must press the [Teach] button on the sensor
and complete step 2 within 60 seconds.
2. Click the switch paddle ON three times, OFF three times, and ON three times quickly, for a
total of nine consecutive clicks. The relay will toggle and the Power LED will indicate the
switch is linked.
Clear Button
The [C lear] button can be used to reset the controller either to its pre-commissioned state or
to its factory default state.
To reset to pre-commissioned state:
1. Press and hold the [C lear] button until the red Power and green Learn LEDs start blinking.
2. Release the [C lear] button. The LEDs repeat a blink code by color to indicate the type and
number of devices linked to each channel at pre-commissioning.
To reset to factory default state:
1. Press and hold the [C lear] button until the red Power and green Learn LEDs start blinking,
and continue to hold for 15 seconds until the LEDs stay on solid.
2. Release the [C lear] button. The Power LED displays solid red to indicates factory default
state.
LED Display
The LEDs are enabled by default. They can be disabled by adjusting a configuration parameter
using Garibaldi Pro software. If disabled, the LEDs are only lit for the configured time when a
controller button is pressed, when in Link mode, or if the remote management
Action
command is used to toggle the light.