Station Miscellaneous
38
Remove or Install the Wall Plate
Remove Wall Plate
After station installation is complete, to gain further access to the
features and set station
, you must first remove the station wall plate.
The wall plate is secured to the station with magnets that are attached to the wall plate.
1.
Using your index finger and thumb, lift the left and right side edges of the bottom of the
wall plate, disengaging the magnets. The magnets that secure the wall plate are strong.
You will need a good grip on the plate to lift it away.
2.
When the bottom of the wall plate is free from the magnets, continue lifting until the top
of the plate is free from the tabs on the top of the station electronics assembly.
Install Wall Plate
1.
Align the top of the wall plate to the station and angle the bottom
approximately 20 degrees.
2.
Hook the top of the wall plate to the tabs located on the station
electronics assembly. To ensure the wall plate is hooked properly on the
top hook, wiggle it slightly side to side.
3.
Swing the bottom of the wall plate down until the magnets engage.
4.
If the wall plate does not fully attach automatically, wiggle the bottom
of the plate until all of the magnets are seated properly to the station
and the plate is secure.
Note:
When installing a multi-gang wall plate to a station and the stations are not
aligned properly in the back box, the wall plate will not attach properly.
Loosen the screws that secure the station to the back box, adjust each station to
improve the alignment, secure the screws, then retry wall plate installation.
Содержание Echoflex Elaho Inspire Station
Страница 47: ...Station Miscellaneous 42 ...
