ETC Installation Guide
ColorSource PAR Pearl v1.7
ColorSource PAR Pearl v1.7
Page 2 of 16
ETC
Safety
Read the entire manual before using this equipment.
CAUTION:
• Risk of eye injury. Do not stare directly into the light.
• Do not operate in proximity to flammable materials.
WARNING:
Disconnect the fixture from power and DMX and allow
it to cool before performing any cleaning and
maintenance.
WARNING:
The ColorSource PAR Pearl is a Directly Controlled
Luminaire suitable for use in emergency lighting
applications in accordance with 2017 National Electrical
Code section 700.24 when used with an ETC DMX
Emergency Bypass Controller. Equipment intended for
this purpose must be properly selected, installed, and
maintained so that facility conformance can be
obtained. Installation and servicing shall be performed
by qualified service personnel.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
• READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• Do not use outdoors.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition.
• Do not use this equipment for other than intended use.
• SAVE THESE INSTRUCTIONS
