XETK-S4.2 - User’s Guide
26
ETAS
Installation
5
Installation
In this chapter, the hardware installation of the XETK-S4.2 is described.
5.1
Connection to the ECU
For connecting the XETK-S4.2 to the ECU two XETK adapter cables are recom-
mended:
• at CON6 adapter ETAI4 and
• at CON7 adapter ETAI8.
The adapter cables are to be ordered separately (refer chapter "Ordering Infor-
mation" on page 51).
The suitable connectors JST-7 and ERNI-12 (see Fig. 5-2 for additional connector
details) should have been populated onto the ECU PCB for adapters ETAI4 and
ETAI8.
Fig. 5-1
XETK-S4.2 Connection to the ECU
CAUTION!
Some components of the interface board may be damaged or
destroyed by electrostatic discharges. Please keep the board in its
storage package until it is installed.
The board should only be taken from its package, configured, and
installed at a work place that is protected against static discharge.
CAUTION!
Risk of short circuiting the internal signals of the XETK!
When you mount the XETK to the ECU, you must ensure that the
screws and washers used will not penetrate the XETK printed circuit
board.
ETAI4
XETK-S4.2
ETAI8
