ETAS
Introduction
XETK-S30.0 - User’s Guide
15
3
Introduction
This section contains information about the basic features and applications of
the XETK-S30.0 Interface Board (ETK = Emulator Test Probe), hints to system
requirements for operating the XETK-S30.0, and other details.
3.1
Applications
The XETK-S30.0 is an emulator probe for the Infineon AURIX microcontroller
family. It is a typical serial XETK.
Fig. 3-1
XETK-S30.0
The XETK-S30.0 supports the standard full duplex 100Base-T Ethernet inter-
face and can be connected directly or via ES51x/ES59x/ES600 modules to the
PC. No additional ETAS modules are required for the access to the ECU. The
XETK-S30.0 can be used for rapid prototyping applications (bypass) as well as
for measurement and calibration applications.
NOTE
For supported Infineon AURIX microcontrollers, refer to chapter 7.1.3
on page 32.
XETK-S30.0
XETK ECU interface connector
10 pin SAMTEC
XETK power supply connector
6 pin MOLEX
Power supply for ED devices (VDDS-
BRAM)
min. 1.25 V
SBRAM sense
Yes, on board or external sense
Pinless triggering
Yes
Timer triggering
Yes
