ETAS ES5340.2, Руководство пользователя

Страница: 94 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 94
Configuring the Hardware in LABCAR-RTC ETAS
Defining the Default Values
1. Select the "Data" tab to configure default values
for the outputs.
Four different settings exist for the output control:
5.3.7 Signal Output via the Digital Multiplexer
For output of the digital signals, an item must be defined for a digital output
multiplexer.
Configuring the Signal Sources of the Digital Multiplexer
1. Right-click the "ES5340-Master" item and select
Add Item .
2. In the list, select the "ES5340-Digital-Out-Mux"
item and click OK .
The item is added.
3. Switch to the "Signals" tab.
In the "Output Select" column, you can now define
a signal source for each of the eight output pins.
4. To do so, click the corresponding cell in the table.
The following signal sources are available:
– Digital position sensors
Note
For each "ES5340-Master" item, only one digital multiplexer can be config-
ured.