ETAS ES160.1, Руководство пользователя

Страница: 26 / 48

ETAS Commissioning
ES16x.1 - User Guide 26
4.2 Web Interface
The connection mode (Master/Slave/Auto) and the connection speed (100/
1000 Mbit/Auto) to the Automotive Ethernet can be configured via a web inter -
face. An Internet connection is not required.
4.2.1 Determining IP Address
You can determine the IP address of the module with the HSP Update Tool .
You can find the tool in the Download Center on the ETAS web page.
1. Start the HSP Update Tool.
2. Search for the hardware with <C
TRL
> + <
H
> .
3. In the Hardware window, mark the desired module.
4. Open the Properties window with <A
LT
> + <E
NTER
> .
> In the Properties window under Communication >
Communication Parameters , you will find the IP address of
the module.
4.2.2 Manual Master-Slave Configuration
The Master-Slave configuration of the Automotive Ethernet connection can be
set manually via a web interface.
1. Open a browser and enter the IP address of the module.
2. Click
Configure .
3. Remove the checkmark at Auto Config in the area AE .
4. Mark the desired mode (Master/Slave) in the area AE MODE .
5. Click Save to confirm the input.
NOTE
The settings in the web interface are not saved permanently. If the module is
disconnected from the power supply, all settings are set back to the default
value.