ETAS CBN101.1, Руководство пользователя

Страница: 16 / 34

CBN101.1/CBN103.1/CBN105.1/CBN107.1 - User’s Guide 16
Hardware description ETAS
• The output voltage of the A/D module (sensor supply voltage of the mod-
ule) or the voltage that is used as the power supply of the Isolating Mea-
surement Probe, must be manually set to 12 V. The following screenshot
shows this setting when INCA is used as application software:
• Adjustment and calibration values for the combination of Isolating Mea-
surement Probe and A/D module must be manually entered by the user in
the application software for every Isolating Measurement Probe.
ETAS provides these values in a calibration certificate for every Isolating
Measurement Probe. In the supplied calibration certificate, which is
uniquely assigned to each unit of the measurement probe via the serial
number, the following adjustment and calibration values can be found:
– Actual output v10 V at input voltage of 10.00455 V
– Actual output voltage -10 V at input voltage of

-10.00275 V
The following screenshot shows this setting of the sample values when
using INCA as application software:
• The measuring range required for the Isolating Measurement Probe must
be set manually.
The adjustment and calibration values used here are sample values. The
values for your measurement probe variant can be found in the supplied
calibration certificate of the measurement probe.
2.3.2 Expanded functions when using the TEDS information of the Isolating Measure-
ment Probes CBN101.1 and CBN107.1
The following information is implemented in the TEDS of the measuring channel
of the Isolating Measurement Probes CBN101.1 and CBN107.1:
• Magnitude of operating voltage of the Isolating Measurement Probe
CBN101.1/CBN107.1,
Note