38
Etac / Prio / www.etac.com
15-20 mm
5 mm
12 Nm
1
1
2
3
2
3
4
5
5 mm
Min 0.2
Max 1.2
15. Settings, readjustments
Brake adjustment
The brakes are variably settable
1. Loosen the screw a few turns.
2. Adjust the brake position
3. The brake block must be approximately 15-20 mm from the tyre
when the brake is not being applied.
4. Ensure that the brake is positioned straight in the track. Tighten the
nut with approximately 5 Nm.
Test the brakes!
5. Make sure that the nut is positioned correctly and locks into the nut
pocket on the inside.
The brakes are parking brakes and must not be used as motion
brakes.
Brake lever adjustment
Rear wheel with quick-release
The distance between the hub sleeve and the locking balls can be
adjusted by adjusting the nut on the outside of the hub. The distance
between the hub sleeve and the locking balls should be 0.2 to 1.2
mm.
During installation, check that the rear wheel is securely
mounted. The button in the hub should pop out to the original
position. Test by pulling the wheel.
Содержание Prio 13420305
Страница 43: ...43 Etac Prio www etac com...