35
Etac / Crissy / www.etac.com
Swing-Aw
ay
Active
The back support height is variably adjustable (See
“
Chair options
”). Loosen the screws (A) 2-3 turns to
set the height of the back support. Ensure that both
sides are at the same height by checking against the
ruler (B) on the back of the back tube. Tighten the
screws securely.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
5 mm
The contour of the back support upholstery is indi-
vidually adjustable by using the five Velcro straps and
the back support cover.
-
Allow the cover plenty of room between seat
and back support, so that it is possible to “sit in”
against the back support.
-
Loosen all the straps and ensure that the user is
sitting as far back in the seat as possible.
-
Tighten the straps so that they follow the con-
tours of the back and give support to the lumbar
region.
Do not over-tighten the upper Velcro straps as this
can prevent the cross-brace from unfolding properly,
i.e. the back tubes do not sit flush in the side-
frames.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
8. Settings Back support 2C
Adjusting back support height
Adjustment of back support upholstery
