eta Mole E3, Руководство по эксплуатации

Страница: 15 / 32

Installation
15
When assembling, pay attention to the sequence of
the spring pulls, which can be seen in their plan. The
distances for the cable ties are shown in diagram
Fig.
2-2: "Clearance/gaps for fastening the spring
balancers"
.
Fig. 4-13: Pellet hose mounted on the spring pulls
Do not cut off the ends of the cable ties if they
need to be opened again. The ends are cut off
after the function test.
Pass the pellet hose through the hose clamps to the
wall bracket.
Then check the required length of the pellet hose.
The furthest corner in the store, seen from the
first spring pulls "H", still has to be reached. If the pellet
hose is too long in this position, it must be shortened.
This is because a pellet hose that is too long can cause
problems.
Fig. 4-14: Checking the hose length
Also check the accessibility to all other corners,
especially if there are niches or protrusions in the store
room.